Sonic, a blue R35 GT-R, bolted to the ProHub hub dyno in the VOLKOV dyno bay
Rated over 3000hp

Mainline ProHub dyno

Precision without compromise. One of only a handful of these systems in the UK and Europe. Most of our tuning is done here, in the safest environment there is, then proven on the road, at the drag strip and on track.

The VOLKOV difference

Not chasing numbers

Dyno tuning isn't about a big figure on a sheet. It's about reliable, usable performance. We work on high-performance cars and R35 GT-Rs, from stock-engine fast road setups to 1000+ whp track and drag cars, with a focus on drivability, control and, above all, long-term reliability.

The dyno is where we do the majority of the work, safely and precisely. Then every tune is tested on the road, at the drag strip and on track in real conditions. Dyno first, real world second, never one without the other.

Mainline dyno screen showing 964.6hp and 816.8lb ft at the hubs
Why a hub dyno

Repeatable, safe, accurate

No tyres in the way

The dyno bolts straight to the hubs. No wheel slip, no tyre deformation and no tyre blowing up at extreme power.

No straps to let go

The car is bolted to the dyno, not strapped down on rollers. Nothing to snap, nothing to shift.

Repeatable results

Run after run reads the same, so a change in the numbers is a real change in the tune, not noise.

Built-in weather station

Every run is automatically corrected for the conditions on the day, so results compare fairly whatever the weather.

Precise load control

We can hold the engine at any rpm and load and creep up on fuelling and timing in a controlled way, without putting the engine at risk.

Real power at the wheels

Before an R35 GT-R goes on, we convert it to rear-wheel drive, mechanically and electronically. You see the true power going through the wheels.

The true dyno for performance cars at this level.

Rated beyond 3000hp. Your car won't trouble it.

The Mainline ProHub 3000 hub dyno at VOLKOV Motors: control cabinet with twin screens and both power absorption modules
The machine

Mainline ProHub 3000

A serious piece of professional equipment, built for high-powered street and race cars. It measures real torque at the hubs, so the numbers you see are the numbers your car makes.

Rated power3000hp at the hubs
Axle torque capacity9,000Nm (6,638lb ft)
Speed ratingUp to 5,000 axle rpm, 400mph road speed
Load controlTwin eddy current absorbers, feedforward + PID control
  • Measured, not guessed: power is calculated from torque measured by precision load cells on each hub, not estimated from roller inertia.
  • No tyres, no slip: billet steel adapters bolt straight to the hubs, removing tyre pressure, wheel spin and strap variables.
  • Steady-state tuning: holds the car at any rpm and load, so every cell of the map is tuned properly, not guessed between pulls.
  • Built-in weather station with automatic correction to international standards, so results compare fairly day to day.
  • Full data logging: twin wideband lambda, twin 7-bar boost sensors and CAN logging, live on screen while we tune.
  • Left-to-right torque balancing, plus drag-strip run simulation for drag cars.
On the dyno

On the hubs

Dyno hire

Hire our hub dyno

£250 + VAT per hour. Bring your car and your own tuner. We set the car up on the dyno and run it for you, so all your tuner has to do is tune.

Arrive with your car ready to run in rear-wheel drive (RWD). If it's all-wheel drive and not ready for the dyno, we can remove the front prop shaft on our ramp for an additional cost.

Call 01234 331613Book your car in